mark - Win32 Multimedia Programmer's Reference (mmedia.hlp)

mark

The mark command controls recording and erasing of marks on the videotape. VCR devices recognize this command.

wsprintf(lpstrCommand, "mark %s %s %s", lpszDeviceID, lpszMark,
lpszFlags);

Parameters
lpszDeviceID
Identifier of an MCI device. This identifier or alias is assigned when the device is opened.

lpszMark
One of the following flags:

erase	Erases a mark at the current position, if one exists. To erase a mark, first seek to the mark and then issue the mark "erase" command.
write	Writes a mark at the current position. The VCR might need to be in play or record mode for this command to succeed.

lpszFlags

Can be "wait", "notify", or "test". For more information about these flags, see The Wait, Notify, and Test Flags.

Return Values
Returns zero if successful or an error otherwise.

Remarks
Marks are special signals written to the content that can be detected by the VCR during high-speed searches. Marks are VCR specific.

More Online Helps